Goodman Furnace Newer single-stage — alphanumeric display control (RS6621008) EE3 Error Code
What the EE3 code means
Primary limit circuit open on newer Goodman single-stage furnaces with the alphanumeric display control. The furnace overheated, most often from restricted airflow.
Likely causes
- dirty air filter
- closed registers or blocked return
- blower problem
- restricted ductwork
How to fix it — step by step
- Turn the thermostat down and let the furnace cool
- Replace the air filter if it is dirty or clogged
- Open all supply registers and make sure return vents are not blocked by furniture
- Restore the heat call and watch whether the code returns
- If the limit code repeats, stop and call a licensed HVAC technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the limit switch.
Shop the limit switch at RepairClinic or Amazon
Also tied to this fault: blower motor - Shop at RepairClinic or Amazon
Parts that commonly fix the EE3 code
- limit switch - Shop at RepairClinic or Amazon
- blower motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace Newer single-stage — alphanumeric display control (RS6621008) error codes
See all Goodman Newer single-stage — alphanumeric display control (RS6621008) codes & guides →