Whirlpool Dryer Cabrio Steam F4 E4 Error Code
What the F4 E4 code means
Low line 2 voltage / voltage supply error: the L2 leg of the 240-volt power supply is missing.
Likely causes
- Tripped breaker or blown fuse on the L2 leg
- Loose power cord wiring on the dryer terminal block → Shop the power cord at RepairClinic
- Damaged power cord
- Failed electronic control board → Shop the electronic control board at RepairClinic
How to fix it — step by step
- Check the house breaker supplying the L2 leg and reset it if tripped
- Unplug the dryer and restore power after 1 minute, then retry
- If L2 voltage is still missing, consult a qualified electrician - do not rewire the terminal block yourself unless qualified
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the power cord.
Shop the power cord at RepairClinic or Amazon
Also tied to this fault: electronic control board - Shop at RepairClinic or Amazon
Parts that commonly fix the F4 E4 code
- power cord - Shop at RepairClinic or Amazon
- electronic control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.