Whirlpool Dryer Cabrio Steam F3 E3 Error Code
What the F3 E3 code means
Inlet thermistor failure: the control detects a failed inlet temperature sensor.
Likely causes
- Failed inlet thermistor
- Loose or damaged thermistor wiring
- Failed electronic control board
How to fix it — step by step
- Unplug the dryer for 1 minute and restore power; retry a heated cycle
- Clean the lint screen and check vent airflow
- If the code returns, call for service to test the inlet thermistor (about 49,000-50,000 ohms at room temperature) → Shop the inlet thermistor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the inlet thermistor.
Parts that commonly fix the F3 E3 code
- inlet thermistor - Shop at RepairClinic or Amazon
Before you buy: check the inlet thermistor first
Test: Remove at least one wire from the thermistor and measure resistance across its terminals at room temperature.
A good one reads: About 11,200 Ω at 75°F ambient (iFixit Whirlpool stackable dryer guide; Whirlpool dryer tech sheets rate the thermistor at a nominal 10 kΩ ±3%). Replace it if the reading is off by more than about 10–15%.
Test values from ifixit.com documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.