Whirlpool Dryer Cabrio Steam F3 E1 Error Code
What the F3 E1 code means
Exhaust thermistor failure: the control detects a failed exhaust temperature sensor (open or shorted).
Likely causes
- Failed exhaust thermistor → Shop the exhaust thermistor at RepairClinic
- Loose or damaged thermistor wiring
- Failed electronic control board
How to fix it — step by step
- Unplug the dryer for 1 minute and restore power; retry a cycle
- Clean the lint screen and vent, since overheating can stress the sensor
- If the code returns, call for service to test the thermistor (about 10,000-11,000 ohms at room temperature) and replace it if faulty
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the exhaust thermistor.
Parts that commonly fix the F3 E1 code
- exhaust thermistor - Shop at RepairClinic or Amazon
Before you buy: check the exhaust thermistor first
Test: Remove at least one wire from the thermistor and measure resistance across its terminals at room temperature.
A good one reads: About 11,200 Ω at 75°F ambient (iFixit Whirlpool stackable dryer guide; Whirlpool dryer tech sheets rate the thermistor at a nominal 10 kΩ ±3%). Replace it if the reading is off by more than about 10–15%.
Test values from ifixit.com documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.