Whirlpool Dryer Cabrio Steam F3 E2 Error Code
What the F3 E2 code means
Moisture sensor failure: the control is not getting a proper signal from the moisture sensor bars inside the drum.
Likely causes
- Residue build-up on the moisture sensor strips
- Metal object shorted across the two sensor bars
- Loose or damaged moisture sensor wire harness → Shop the moisture sensor wire harness at RepairClinic
- Dryer not level so clothes do not contact the sensor strips
How to fix it — step by step
- Clean residue off the moisture sensor strips inside the drum
- Remove any metal object touching both sensor bars
- Level the dryer so garments tumble against the sensor strips
- Unplug for 1 minute and retry; if the code returns, the harness or control may need service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the moisture sensor wire harness.
Shop the moisture sensor wire harness at RepairClinic or Amazon
Also tied to this fault: electronic control board - Shop at RepairClinic or Amazon
Parts that commonly fix the F3 E2 code
- moisture sensor wire harness - Shop at RepairClinic or Amazon
- electronic control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.