Whirlpool Dryer Cabrio Steam F1 E3 Error Code
What the F1 E3 code means
Control mismatch: the control console and electronic control board do not match, or the wrong control board was installed.
Likely causes
- Wrong electronic control board installed for the model → Shop the electronic control board at RepairClinic
- Wrong control console installed → Shop the control console at RepairClinic
- Mismatched replacement parts
How to fix it — step by step
- Unplug the dryer
- Check the replacement part number against your dryer model number if a board or console was recently replaced
- Install the correct part for the model, or call for service if no parts were changed
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the electronic control board.
Shop the electronic control board at RepairClinic or Amazon
Also tied to this fault: control console - Shop at RepairClinic or Amazon
Parts that commonly fix the F1 E3 code
- electronic control board - Shop at RepairClinic or Amazon
- control console - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.