Whirlpool Dryer Cabrio Steam F1 E1 Error Code
What the F1 E1 code means
Motor relay stuck on the electronic control board: the control detects an internal motor relay failure, and the relay is part of the control board.
Likely causes
- Failed electronic control board
- Motor relay failure inside the control
How to fix it — step by step
- Unplug the dryer and restore power after 1 minute to see if the code clears
- If the code returns, call for service - the electronic control board normally needs replacement → Shop the electronic control board at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the electronic control board.
Parts that commonly fix the F1 E1 code
- electronic control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.