Trane Furnace Single-stage IFC — XR80/XR90/XR95/XB80/XB90 9 flashes
What it should look like on your machine
then it repeats
9 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
On Trane single-stage furnaces (XR80, XR90, XR95, XB80, XB90 families) using the replacement integrated furnace control covered in Trane guide 18-CH92D1-1A-EN, the red LED flashes 9 times: an igniter relay fault — the control's igniter relay or igniter circuit has failed.
Likely causes
- Failed igniter relay on the control board → Shop the control board at RepairClinic
- Open or failed hot surface igniter → Shop the hot surface igniter at RepairClinic
- Loose igniter wiring connection
How to fix it — step by step
- Note which LED is flashing and confirm the thermostat is calling for heat and the furnace has power
- Reset power once (off 30 seconds, then on) and listen for the normal start sequence
- Do not rewire the furnace electrical connections yourself — on two-stage models this code is a polarity/grounding fault
- Call an HVAC technician (or an electrician for the polarity/grounding fault) to test the igniter circuit or correct the wiring
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the hot surface igniter.
Shop the hot surface igniter at RepairClinic or Amazon
Also tied to this fault: control board - Shop at RepairClinic or Amazon
Parts that commonly fix it
- hot surface igniter - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Trane Furnace Single-stage IFC — XR80/XR90/XR95/XB80/XB90 problems
See all Trane Single-stage IFC — XR80/XR90/XR95/XB80/XB90 codes & guides →