Trane Furnace Single-stage IFC — XR80/XR90/XR95/XB80/XB90 2 flashes
What it should look like on your machine
then it repeats
2 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
On Trane single-stage furnaces (XR80, XR90, XR95, XB80, XB90 families) with the integrated furnace control (IFC), the red LED flashes 2 times: system lockout — ignition retries or recycles were exceeded, so the furnace tried to light several times, failed, and locked out.
Likely causes
- Failed or cracked hot surface igniter → Shop the hot surface igniter at RepairClinic
- Dirty flame sensor not proving flame → Shop the flame sensor at RepairClinic
- Gas supply off or low gas pressure
How to fix it — step by step
- Note the code and which LED is flashing before resetting, because a power cycle erases it
- Confirm the thermostat is set to Heat and calling for heat
- Check that the gas shutoff valve to the furnace is open and other gas appliances work
- Check outdoor vent and intake terminations for snow, ice or debris, and check the condensate drain for clogs or freezing
- Replace a dirty air filter, which can contribute to shutdowns
- Turn furnace power off for 30 seconds and back on once to clear the lockout; if the code returns, stop resetting and call a technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the hot surface igniter.
Shop the hot surface igniter at RepairClinic or Amazon
Also tied to this fault: flame sensor - Shop at RepairClinic or Amazon; gas valve - Shop at RepairClinic or Amazon
Parts that commonly fix it
- hot surface igniter - Shop at RepairClinic or Amazon
- flame sensor - Shop at RepairClinic or Amazon
- gas valve - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Trane Furnace Single-stage IFC — XR80/XR90/XR95/XB80/XB90 problems
See all Trane Single-stage IFC — XR80/XR90/XR95/XB80/XB90 codes & guides →