Trane Furnace Single-stage IFC — XR80/XR90/XR95/XB80/XB90 5 flashes
What it should look like on your machine
then it repeats
5 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
On Trane single-stage furnaces (XR80, XR90, XR95, XB80, XB90 families) with the integrated furnace control (IFC), the red LED flashes 5 times: flame sensed when no flame should be present — the control sees a flame signal while the gas valve should be closed, which is a safety fault.
Likely causes
- Gas valve leaking or stuck open
- Shorted or damaged flame sensor wiring → Shop the flame sensor at RepairClinic
- Failed control board misreading the flame signal → Shop the control board at RepairClinic
How to fix it — step by step
- Turn the furnace power switch off and close the gas shutoff to the furnace
- Do not keep resetting or trying to run the furnace — this code is a safety fault — flame sensed with the gas valve closed is a safety fault → Shop the gas valve at RepairClinic
- If you smell gas, leave the house and call the gas utility from outside
- Call a technician to find the cause before the furnace runs again
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the gas valve.
Shop the gas valve at RepairClinic or Amazon
Also tied to this fault: flame sensor - Shop at RepairClinic or Amazon; control board - Shop at RepairClinic or Amazon
Parts that commonly fix it
- gas valve - Shop at RepairClinic or Amazon
- flame sensor - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Trane Furnace Single-stage IFC — XR80/XR90/XR95/XB80/XB90 problems
See all Trane Single-stage IFC — XR80/XR90/XR95/XB80/XB90 codes & guides →