Trane Furnace Single-stage IFC — XR80/XR90/XR95/XB80/XB90 6 flashes

What it should look like on your machine

then it repeats

6 flashes - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

On Trane single-stage furnaces (XR80, XR90, XR95, XB80, XB90 families) with the integrated furnace control (IFC), the red LED flashes this count: 115 volt AC power reversed or improper ground — line polarity is reversed at the furnace or the ground is poor.

Likely causes

  1. Line and neutral reversed at the furnace or disconnect
  2. Missing or poor earth ground
  3. Recent electrical panel or outlet work

How to fix it — step by step

  1. Check that the furnace breaker is on and the furnace switch is on
  2. Note whether the code appeared right after electrical work in the home
  3. Do not swap wires or open the electrical junction yourself
  4. Call an electrician or HVAC technician to correct polarity and grounding

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace Single-stage IFC — XR80/XR90/XR95/XB80/XB90 problems

See all Trane Single-stage IFC — XR80/XR90/XR95/XB80/XB90 codes & guides →