Trane Furnace Single-stage IFC — XR80/XR90/XR95/XB80/XB90 7 flashes

What it should look like on your machine

then it repeats

7 flashes - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

On Trane single-stage furnaces (XR80, XR90, XR95, XB80, XB90 families) with the integrated furnace control (IFC), the red LED flashes 7 times: a gas valve circuit error — the control detects a fault in the gas valve circuit, such as voltage present when the valve should be off.

Likely causes

  1. Shorted gas valve wiring
  2. Failed gas valve solenoid
  3. Failed control board gas valve relay

How to fix it — step by step

  1. Turn furnace power off and note the code and which LED is flashing for the technician
  2. Confirm the gas shutoff valve to the furnace is open and other gas appliances work
  3. Do not attempt to test or rewire the gas valve circuit → Shop the gas valve at RepairClinic
  4. If you smell gas, leave the house and call the gas utility from outside
  5. Call a technician to test the gas valve, igniter, flame sensor and control board → Shop the control board at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace Single-stage IFC — XR80/XR90/XR95/XB80/XB90 problems

See all Trane Single-stage IFC — XR80/XR90/XR95/XB80/XB90 codes & guides →