Trane Air Conditioner Demand defrost control — A4HP4/4TWA split heat pump Defrost board 3 flashes

What it should look like on your machine

then it repeats

3 flashes - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

Low pressure switch is open, flashed by the fault LED on the demand defrost control board inside the outdoor unit control box of a Trane split heat pump (A4HP4 / 4TWA series, Service Facts A4HP4017D-SF). The 3-flash code clears when/if the low pressure cut-out closes.

Likely causes

  1. Low refrigerant charge / refrigerant leak
  2. Restriction in the refrigerant circuit
  3. Low airflow causing low suction pressure
  4. Open low pressure switch

How to fix it — step by step

  1. Replace a dirty indoor filter and confirm the indoor blower runs
  2. Turn the system off if the code keeps returning
  3. Have a technician check refrigerant pressures and test the low pressure switch → Shop the low pressure switch (lpco) at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Trane Air Conditioner Demand defrost control — A4HP4/4TWA split heat pump problems

See all Trane Demand defrost control — A4HP4/4TWA split heat pump codes & guides →