GE Washer Front-Load E64 Error Code
What the E64 code means
Unexpected open door while running on GE front-load washers: the door was detected open during operation.
Likely causes
- Failing door lock assembly losing lock mid-cycle
- Door strike/latch wear
- Overloaded drum forcing the door
- Loose lock wiring
How to fix it — step by step
- Stop the cycle and re-close the door firmly after checking the seal
- Run a smaller load so nothing presses on the door
- If the door pops or the code returns, arrange service for the lock assembly → Shop the door lock assembly at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the door lock assembly.
Parts that commonly fix the E64 code
- door lock assembly - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.