GE Washer Front-Load E23 Error Code
What the E23 code means
Flood-protect / overfill fault on GE front-load washers: the washer detected too much water, or the foam/level switch closed while the washer was idle, and ran a protective drain.
Likely causes
- Water inlet valve not shutting off properly
- Failed water level (pressure) sensor giving a false high reading → Shop the water level sensor at RepairClinic
- Excess suds from too much or non-HE detergent fooling the level sensing
- Loose or damaged wiring to the water level sensor
How to fix it — step by step
- Turn off both water supply valves and unplug the washer
- If the tub is overfilled, let it drain and check whether water keeps entering with the power off - if it does, keep the valves shut
- Use less HE detergent and run a rinse to clear excess suds
- Do not keep running cycles if the code returns
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve assembly.
Shop the water inlet valve assembly at RepairClinic or Amazon
Also tied to this fault: water level sensor - Shop at RepairClinic or Amazon
Parts that commonly fix the E23 code
- water inlet valve assembly - Shop at RepairClinic or Amazon
- water level sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.