GE Washer Front-Load E66 Error Code
What the E66 code means
Water temperature sensor fault on GE front-load washers: the temperature sensor is defective - listed as open in the GE service table.
Likely causes
- Open water temperature sensor (thermistor) → Shop the water temperature sensor at RepairClinic
- Loose or damaged sensor wiring harness
- Failed sensor connector
How to fix it — step by step
- Unplug the washer for a few minutes and retry once
- Check the wash temperature behaves normally on a warm cycle
- If E66 returns, the temperature sensor needs professional testing and replacement
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water temperature sensor.
Shop the water temperature sensor at RepairClinic or Amazon
Also tied to this fault: wire harness - Shop at RepairClinic or Amazon
Parts that commonly fix the E66 code
- water temperature sensor - Shop at RepairClinic or Amazon
- wire harness - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.