GE Washer Front-Load E42 Error Code
What the E42 code means
Drive motor instantaneous / excess current on GE front-load washers: the motor drew too much current, most often because the load is too heavy.
Likely causes
- Overloaded drum
- Foreign object trapped between the spin basket and outer tub
- Basket that does not rotate freely
- Loose motor wiring or failing drive motor / inverter board → Shop the drive motor at RepairClinic
How to fix it — step by step
- Remove part of the load and restart the cycle with a smaller load
- Turn the basket by hand (power off) to check it spins freely
- Check pockets and remove any trapped items you can see at the basket edge
- Unplug for a few minutes, then retry once
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drive motor.
Shop the drive motor at RepairClinic or Amazon
Also tied to this fault: inverter control board - Shop at RepairClinic or Amazon
Parts that commonly fix the E42 code
- drive motor - Shop at RepairClinic or Amazon
- inverter control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.