GE Washer Front-Load E22 Error Code
What the E22 code means
Fill timeout on GE front-load washers: the washer did not fill, or filled too slowly, and timed out (about 8 minutes).
Likely causes
- Water supply valves behind the washer not fully open
- Clogged inlet valve screens or kinked fill hoses
- Low household water pressure or frozen fill lines in winter
- Drain siphon problem draining water as it fills
- Failed water inlet valve assembly → Shop the water inlet valve assembly at RepairClinic
How to fix it — step by step
- Make sure both hot and cold supply valves behind the washer are fully open
- Straighten any kinked fill hoses and check the drain hose is not pushed too far into the standpipe (siphoning)
- Unplug the washer, turn off the water, and clean the sediment screens in the inlet hose connections
- Restart a cycle and watch whether it fills at a normal rate
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve assembly.
Shop the water inlet valve assembly at RepairClinic or Amazon
Parts that commonly fix the E22 code
- water inlet valve assembly - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.