GE Washer Front-Load E30 Error Code
What the E30 code means
No drain on GE front-load washers: the control does not detect the drain pump running or the washer cannot drain at all.
Likely causes
- Clogged drain pump (large-item) filter
- Excess suds blocking drainage
- Kinked or blocked drain hose
- Failed drain pump
How to fix it — step by step
- Unplug the washer
- Open the small access door at the bottom front and clean the drain pump filter / large-item trap over a shallow pan → Shop the drain pump at RepairClinic
- Check the drain hose for kinks and make sure the house drain is clear
- Reduce detergent if the load was very sudsy, then retry a Drain & Spin cycle
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drain pump.
Parts that commonly fix the E30 code
- drain pump - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.