GE Washer Front-Load E67 Error Code
What the E67 code means
Water temperature sensor shorted on GE front-load washers: the temperature sensor circuit is shorted.
Likely causes
- Shorted water temperature sensor (thermistor) → Shop the water temperature sensor at RepairClinic
- Pinched or damaged sensor wiring harness
- Moisture in the sensor connector
How to fix it — step by step
- Unplug the washer for a few minutes and retry once
- If the code returns straight away, stop and arrange service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the water temperature sensor.
Shop the water temperature sensor at RepairClinic or Amazon
Also tied to this fault: wire harness - Shop at RepairClinic or Amazon
Parts that commonly fix the E67 code
- water temperature sensor - Shop at RepairClinic or Amazon
- wire harness - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.