GE Washer Front-Load E62 Error Code
What the E62 code means
System contact failure on GE front-load washers: a system contact fault involving the heater, pump, pressure switch or door lock circuit.
Likely causes
- Fault in the heater circuit → Shop the heater at RepairClinic
- Fault in the drain pump circuit → Shop the drain pump at RepairClinic
- Pressure switch circuit fault → Shop the pressure switch at RepairClinic
- Door lock circuit fault
How to fix it — step by step
- Unplug the washer for 5 minutes, then retry once
- Note when in the cycle the code appears (fill, wash, drain) to tell the technician
- Do not keep running the washer if E62 returns
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the heater.
Shop the heater at RepairClinic or Amazon
Also tied to this fault: drain pump - Shop at RepairClinic or Amazon; pressure switch - Shop at RepairClinic or Amazon; door lock assembly - Shop at RepairClinic or Amazon
Parts that commonly fix the E62 code
- heater - Shop at RepairClinic or Amazon
- drain pump - Shop at RepairClinic or Amazon
- pressure switch - Shop at RepairClinic or Amazon
- door lock assembly - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official GE manual is on GE's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.