Electrolux Dishwasher Older Er-code models (EIDW / EWDW series) Er-07 Error Code
What the Er-07 code means
Drain valve failure: in drain mode the control board does not receive proper position feedback from the drain valve (also shown as Er-11 on some models).
Likely causes
- Failed drain valve
- Drain valve wiring fault
- Control board fault
How to fix it — step by step
- Turn power off at the breaker and shut off the water
- Check the drain hose and filters for blockages first
- Restart once; if the code returns, do not keep cycling it
- Book service to test and replace the drain valve → Shop the drain valve at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drain valve.
Parts that commonly fix the Er-07 code
- drain valve - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the tub edge inside the door. It's the key to the right manual pages and the right parts.
Related Electrolux Dishwasher Older Er-code models (EIDW / EWDW series) error codes
See all Electrolux Older Er-code models (EIDW / EWDW series) codes & guides →