Electrolux Dishwasher Older Er-code models (EIDW / EWDW series) Er-01 Error Code

What the Er-01 code means

Water leak detected: the leak detector has found water under the tub, and the control shuts the dishwasher down.

Likely causes

  1. Leaking inlet valve or hose connection → Shop the water inlet valve at RepairClinic
  2. Leaking pump or door seal → Shop the door seal at RepairClinic
  3. Split internal hose
  4. Overflow from excess suds

How to fix it — step by step

  1. Turn off the water supply to the dishwasher
  2. Do not restart it while water is under the tub
  3. Check visible connections under the sink for drips
  4. Book service to find and repair the leak

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the Er-01 code

Before you buy: check the water inlet valve first

Test: Turn off power and water, disconnect the valve's wires, and measure resistance across the solenoid terminals.

A good one reads: 500–1500 Ω for a good valve (PartSelect repair help). A reading of 1 / no change (open) or near zero (shorted) means the valve is defective.

Test values from Partselect.com documentation - confirm against your model's own tech sheet.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the tub edge inside the door. It's the key to the right manual pages and the right parts.

Related Electrolux Dishwasher Older Er-code models (EIDW / EWDW series) error codes

See all Electrolux Older Er-code models (EIDW / EWDW series) codes & guides →