Electrolux Dishwasher Older Er-code models (EIDW / EWDW series) Er-02 Error Code
What the Er-02 code means
Thermistor / turbidity sensor failure: the control cannot read water temperature or soil level correctly.
Likely causes
- Failed thermistor → Shop the thermistor at RepairClinic
- Failed turbidity sensor → Shop the turbidity sensor at RepairClinic
- Sensor wiring fault
- Control board fault
How to fix it — step by step
- Turn power off at the breaker for 5 minutes and restart
- Run a short cycle and note if the code returns
- If Er-02 returns, stop the dishwasher
- Book service to test and replace the sensor
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the thermistor.
Shop the thermistor at RepairClinic or Amazon
Also tied to this fault: turbidity sensor - Shop at RepairClinic or Amazon
Parts that commonly fix the Er-02 code
- thermistor - Shop at RepairClinic or Amazon
- turbidity sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the tub edge inside the door. It's the key to the right manual pages and the right parts.
Related Electrolux Dishwasher Older Er-code models (EIDW / EWDW series) error codes
See all Electrolux Older Er-code models (EIDW / EWDW series) codes & guides →