Whirlpool Oven Older 2-digit-code models F4 Error Code
What the F4 code means
Shorted oven temperature sensor on older 2-digit-code ovens - the same sensor as F3 with the opposite failure. On newer ovens this is F3 E1.
Likely causes
- Shorted oven temperature sensor (RTD) → Shop the oven temperature sensor at RepairClinic
- Pinched sensor harness shorting behind the back panel
- Failed control board sensor input
How to fix it — step by step
- Switch the breaker off for 1 minute, restore it, and try Bake
- If F4 returns, schedule service to test the sensor and harness
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the oven temperature sensor.
Parts that commonly fix the F4 code
- oven temperature sensor - Shop at RepairClinic or Amazon
Before you buy: check the oven temperature sensor first
Test: Unplug the range and measure the oven temperature sensor's resistance at the sensor connector or the control check points in the tech sheet.
A good one reads: 1080 Ω at 21°C / 70°F, rising to 1654 Ω at 177°C / 350°F — add about 2 Ω per 1°F above room temperature (Whirlpool tech sheet 8303103 / W10201489A). If the resistance is not valid, replace the sensor.
Test values from forum.appliancepartspros.com documentation - confirm against your model's own tech sheet.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number on the frame inside the oven door or behind the storage drawer. It's the key to the right manual pages and the right parts.
Related Whirlpool Oven Older 2-digit-code models error codes
See all Whirlpool Older 2-digit-code models codes & guides →