Whirlpool Dishwasher Older HE models (c. 2010-2020 platform) F9 E1 Error Code
What the F9 E1 code means
The control cannot determine the position of the diverter.
Likely causes
- Clogged filter or kinked / clogged drain hose (current platform)
- Garbage disposer knockout plug not removed on a new install, or a blocked air gap
- Defective diverter motor or a leaking diverter seal (older platform), or a failed drain pump → Shop the diverter motor at RepairClinic
How to fix it — step by step
- Remove the filter and clean it thoroughly under running water
- Check the drain hose for kinks, pinches or clogs from the dishwasher to the sink
- If connected to a disposer, make sure it is clear and the knockout plug was removed; clear the air gap if fitted
- Cut power for 30 seconds, restore it, and run a cancel / drain; if the code returns, schedule service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drain pump.
Shop the drain pump at RepairClinic or Amazon
Also tied to this fault: diverter motor - Shop at RepairClinic or Amazon
Parts that commonly fix the F9 E1 code
- drain pump - Shop at RepairClinic or Amazon
- diverter motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number on the tub edge inside the door. It's the key to the right manual pages and the right parts.
Related Whirlpool Dishwasher Older HE models (c. 2010-2020 platform) error codes
See all Whirlpool Older HE models (c. 2010-2020 platform) codes & guides →