Whirlpool Dishwasher Older HE models (c. 2010-2020 platform) F8 E2 Error Code

What the F8 E2 code means

Drain pump electrical problem: a fault in the drain pump circuit.

Likely causes

  1. Defective drain pump (older platform)
  2. Defective water inlet / fill valve (current platform) → Shop the water inlet valve at RepairClinic
  3. Loose wire connectors or a defective main control board

How to fix it — step by step

  1. Cut power for 30 seconds to 1 minute, restore it, and run a cycle
  2. Clean the filters and check for debris around the drain pump cover → Shop the drain pump at RepairClinic
  3. If the code returns, schedule service - the pump / valve needs electrical testing

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the F8 E2 code

Before you buy: check the water inlet valve first

Test: Turn off power and water, disconnect the valve's wires, and measure resistance across the solenoid terminals.

A good one reads: 500–1500 Ω for a good valve (PartSelect repair help). A reading of 1 / no change (open) or near zero (shorted) means the valve is defective.

Test values from Partselect.com documentation - confirm against your model's own tech sheet.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.

Find your model number on the tub edge inside the door. It's the key to the right manual pages and the right parts.

Related Whirlpool Dishwasher Older HE models (c. 2010-2020 platform) error codes

See all Whirlpool Older HE models (c. 2010-2020 platform) codes & guides →