Whirlpool Dishwasher Older HE models (c. 2010-2020 platform) F6 E1 Error Code

What the F6 E1 code means

The dishwasher will not fill: no water is detected in the time allowed.

Likely causes

  1. Water supply turned off, stuck overfill float, or clogged inlet valve screen (fill platform) → Shop the water inlet valve at RepairClinic
  2. User interface / main control communication fault (current platform) → Shop the user interface control at RepairClinic
  3. Low household water pressure (below about 20 psi)

How to fix it — step by step

  1. Make sure the water supply valve to the dishwasher is fully open and the supply hose is not kinked
  2. Lift and lower the overfill float in the front corner of the tub to check it moves freely and clicks
  3. Power-cycle the dishwasher: unplug or breaker off for 30 seconds to 1 minute, then restore power
  4. If the code returns, schedule service

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the F6 E1 code

Before you buy: check the water inlet valve first

Test: Turn off power and water, disconnect the valve's wires, and measure resistance across the solenoid terminals.

A good one reads: 500–1500 Ω for a good valve (PartSelect repair help). A reading of 1 / no change (open) or near zero (shorted) means the valve is defective.

Test values from Partselect.com documentation - confirm against your model's own tech sheet.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.

Find your model number on the tub edge inside the door. It's the key to the right manual pages and the right parts.

Related Whirlpool Dishwasher Older HE models (c. 2010-2020 platform) error codes

See all Whirlpool Older HE models (c. 2010-2020 platform) codes & guides →