Whirlpool Dishwasher Older HE models (c. 2010-2020 platform) F7 E1 Error Code

What the F7 E1 code means

Heater fault: the heating element is open or the water does not heat.

Likely causes

  1. Open / failed heating element (heater platform) → Shop the heating element at RepairClinic
  2. Heater relay failed on the main control board
  3. Wash motor failure (newer platform), or low / no water in the tub → Shop the wash motor at RepairClinic

How to fix it — step by step

  1. Cut power for 1 minute, restore it, and run a heated cycle
  2. Make sure the dishwasher is filling with water normally
  3. If the code returns, schedule service - the heater or motor needs electrical testing

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the F7 E1 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.

Find your model number on the tub edge inside the door. It's the key to the right manual pages and the right parts.

Related Whirlpool Dishwasher Older HE models (c. 2010-2020 platform) error codes

See all Whirlpool Older HE models (c. 2010-2020 platform) codes & guides →