Subaru Sedan Legacy Infotainment system freezing
What this problem usually means
The 2018 Legacy's infotainment system can freeze up, with radio controls and the screen refusing to shut down even after the vehicle is turned off, or refusing to turn on at all. Dealerships traced the fault to an internal short in the computer, and the problem is covered by the Legacy's warranty.
Likely causes
- internal short in the infotainment computer
How to fix it — step by step
- Try turning the vehicle fully off, locking it, and restarting after a few minutes to see if the system resets
- Note whether the screen stays on after shutdown, which can drain the battery
- Disconnect nothing behind the dash; note the symptoms and software behavior for the dealer
- Have a dealer diagnose the internal short and repair or replace the unit under warranty
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the infotainment system.
Parts that commonly fix it
- infotainment system - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Subaru manual is on Subaru's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.