Subaru Sedan Legacy CVT stalling
What this problem usually means
Fifth-generation Legacy models, especially the 2010 model, drew CVT complaints for stalling under braking and when slowing down, with the issue mostly present until 2012. A handful of 2013 owners also had CVT component failures before the problem died down.
Likely causes
- cvt faults causing stalling
How to fix it — step by step
- Pull over safely if the engine stalls while slowing, and restart only when it is safe
- Note whether stalling happens under braking or at low speed and how often
- Check by VIN whether any transmission recall or service campaign applies to your Legacy
- Have a shop diagnose the CVT and repair or replace failed components
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the cvt transmission.
Parts that commonly fix it
- cvt transmission - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Subaru manual is on Subaru's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.