Samsung Oven Current Models (C-Codes) C-F0 Error Code
What the C-F0 code means
Communication error: communication between the main and sub PBA/PCB is interrupted. On certain induction models (NSI6D*9100, NSI6D*9300, NSI6D*9500) Samsung offers a SmartThings software update that can resolve it without service.
Likely causes
- Interrupted main-to-sub board communication
- Loose board connector or wiring
- Outdated firmware on the listed induction models
- Failed main or sub board
How to fix it — step by step
- Turn off the oven and restart it; if it persists disconnect power for at least 30 seconds and reconnect
- On the listed induction models, reset power, connect the range to SmartThings and let the firmware update run, checking the version afterwards
- If you cannot update or the code returns after updating, request service
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the main control board.
Parts that commonly fix the C-F0 code
- main control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.
Find your model number on the frame inside the oven door or behind the storage drawer. It's the key to the right manual pages and the right parts.