Rheem Furnace Seven-segment display — R801V 75 Error Code
What the 75 code means
Venturi air inlet pressure switch open on Rheem R801V furnaces with the 7-segment diagnostic display. The air inlet pressure switch did not prove proper combustion air.
Likely causes
- blocked combustion air inlet
- faulty venturi air inlet pressure switch → Shop the pressure switch at RepairClinic
- inducer problem
How to fix it — step by step
- Check the thermostat is set to Heat and calling for heat
- Check the outdoor vent and intake pipes are clear of snow, ice or debris
- On a high-efficiency model, check the condensate drain line and trap are not clogged or frozen
- Turn power off at the furnace switch for 30 seconds, then back on, and try one heat call
- If the code returns, stop resetting and call a licensed HVAC technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the pressure switch.
Shop the pressure switch at RepairClinic or Amazon
Also tied to this fault: inducer motor - Shop at RepairClinic or Amazon
Parts that commonly fix the 75 code
- pressure switch - Shop at RepairClinic or Amazon
- inducer motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Rheem Furnace Seven-segment display — R801V error codes
See all Rheem Seven-segment display — R801V codes & guides →