Rheem Seven-segment display — R801V Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 7 codes covered.
Shop Rheem Seven-segment display — R801V parts at RepairClinic or Amazon
- 34 — Induced draft (inducer) motor overcurrent on Rheem R801V furnaces with the 7-segment diagnostic display. The inducer motor is drawing too…
- 42 — Flame LED not detected on Rheem R801V furnaces with the 7-segment diagnostic display. The control cannot detect the flame status LED…
- 43 — Ignition pressure switch closed when it should be open on Rheem R801V furnaces with the 7-segment diagnostic display.
- 56 — Ignition pressure switch open when it should be closed on Rheem R801V furnaces with the 7-segment diagnostic display. Ignition-stage draft…
- 71 — Inducer fault on Rheem R801V furnaces with the 7-segment diagnostic display. The induced draft motor cannot run correctly.
- 74 — Gas inlet pressure switch open on Rheem R801V furnaces with the 7-segment diagnostic display. Inlet gas pressure is too low or the switch…
- 75 — Venturi air inlet pressure switch open on Rheem R801V furnaces with the 7-segment diagnostic display. The air inlet pressure switch did not…