Rheem Furnace Seven-segment display — R801V 34 Error Code
What the 34 code means
Induced draft (inducer) motor overcurrent on Rheem R801V furnaces with the 7-segment diagnostic display. The inducer motor is drawing too much current.
Likely causes
- failing inducer motor → Shop the inducer motor at RepairClinic
- blocked inducer or vent causing overload
- inducer wiring fault
How to fix it — step by step
- Check the thermostat is set to Heat and calling for heat
- Check the outdoor vent and intake pipes are clear of snow, ice or debris
- On a high-efficiency model, check the condensate drain line and trap are not clogged or frozen
- Turn power off at the furnace switch for 30 seconds, then back on, and try one heat call
- If the code returns, stop resetting and call a licensed HVAC technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the inducer motor.
Parts that commonly fix the 34 code
- inducer motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Rheem Furnace Seven-segment display — R801V error codes
See all Rheem Seven-segment display — R801V codes & guides →