Rheem Furnace Seven-segment display — R801V 43 Error Code

What the 43 code means

Ignition pressure switch closed when it should be open on Rheem R801V furnaces with the 7-segment diagnostic display.

Likely causes

  1. stuck ignition pressure switch → Shop the pressure switch at RepairClinic
  2. water or debris in the pressure switch hose
  3. faulty pressure switch

How to fix it — step by step

  1. Check the thermostat is set to Heat and calling for heat
  2. Check the outdoor vent and intake pipes are clear of snow, ice or debris
  3. On a high-efficiency model, check the condensate drain line and trap are not clogged or frozen
  4. Turn power off at the furnace switch for 30 seconds, then back on, and try one heat call
  5. If the code returns, stop resetting and call a licensed HVAC technician

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the 43 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Rheem Furnace Seven-segment display — R801V error codes

See all Rheem Seven-segment display — R801V codes & guides →