Rheem Furnace Seven-segment display — R801V 42 Error Code
What the 42 code means
Flame LED not detected on Rheem R801V furnaces with the 7-segment diagnostic display. The control cannot detect the flame status LED circuit.
Likely causes
- control board fault → Shop the control board at RepairClinic
- flame LED circuit failure
How to fix it — step by step
- Turn power off at the furnace switch for 30 seconds, then back on
- Try one heat call and note whether 42 returns
- Do not open the control compartment to chase wiring
- Call a licensed HVAC technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the control board.
Parts that commonly fix the 42 code
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Rheem Furnace Seven-segment display — R801V error codes
See all Rheem Seven-segment display — R801V codes & guides →