Rheem Furnace Older LED blink-code control — Rheem/Ruud (Tech Tip TP0002; not modulating/two-stage/LXE) 5 blinks

What it should look like on your machine

then it repeats

5 blinks - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

Twinning fault on older Rheem/Ruud furnaces whose boards support twinning. Rheem notes some electronic thermostats can cause this fault.

Likely causes

  1. thermostat incompatibility or wiring issue
  2. twinning wiring error
  3. control board fault → Shop the control board at RepairClinic

How to fix it — step by step

  1. Turn power off to both twinned furnaces
  2. Restore power and try one heat call
  3. Note the thermostat model for the technician
  4. Call a licensed HVAC technician if the code returns

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Rheem Furnace Older LED blink-code control — Rheem/Ruud (Tech Tip TP0002; not modulating/two-stage/LXE) problems

See all Rheem Older LED blink-code control — Rheem/Ruud (Tech Tip TP0002; not modulating/two-stage/LXE) codes & guides →