Rheem Furnace Older LED blink-code control — Rheem/Ruud (Tech Tip TP0002; not modulating/two-stage/LXE) 3 blinks
What it should look like on your machine
then it repeats
3 blinks - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Limit circuit open on older Rheem/Ruud furnaces with the blinking status LED board. The furnace overheated, or the manual-reset rollout switch above the burners tripped.
Likely causes
- dirty filter or closed registers restricting airflow
- tripped rollout switch → Shop the rollout switch at RepairClinic
- blower problem
How to fix it — step by step
- Turn the thermostat down and let the furnace cool
- Replace the air filter if it is dirty or clogged
- Open all supply registers and make sure return vents are not blocked by furniture
- Restore the heat call and watch whether the code returns
- If the limit code repeats, stop and call a licensed HVAC technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the limit switch.
Shop the limit switch at RepairClinic or Amazon
Also tied to this fault: rollout switch - Shop at RepairClinic or Amazon
Parts that commonly fix it
- limit switch - Shop at RepairClinic or Amazon
- rollout switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.