Rheem Older LED blink-code control — Rheem/Ruud (Tech Tip TP0002; not modulating/two-stage/LXE) Common Problems
Find your problem in the list below. Each page explains the most likely causes, step-by-step checks you can do yourself, when to call a pro, and the parts that commonly resolve it. 5 problems covered.
Shop Rheem Older LED blink-code control — Rheem/Ruud (Tech Tip TP0002; not modulating/two-stage/LXE) parts at RepairClinic or Amazon
Not sure of the code? Tap along with it
If your Rheem Furnace blinks or beeps a pattern instead of showing a code, tap the button in time with each blink or beep. A pause longer than a second and a half starts a new group - we will match the rhythm to a code.
Your rhythm: -
- 1 blink — Soft lockout for one hour on older Rheem/Ruud furnaces with the blinking status LED board (per Rheem Tech Tip TP0002, not…
- 2 blinks — Pressure switch circuit open on older Rheem/Ruud furnaces with the blinking status LED board. Draft was not proven, commonly from venting…
- 3 blinks — Limit circuit open on older Rheem/Ruud furnaces with the blinking status LED board. The furnace overheated, or the manual-reset rollout…
- 4 blinks — Pressure switch closed when it should be open on older Rheem/Ruud furnaces with the blinking status LED board. The switch contacts are…
- 5 blinks — Twinning fault on older Rheem/Ruud furnaces whose boards support twinning. Rheem notes some electronic thermostats can cause this fault.