Rheem Furnace Older LED blink-code control — Rheem/Ruud (Tech Tip TP0002; not modulating/two-stage/LXE) 4 blinks
What it should look like on your machine
then it repeats
4 blinks - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Pressure switch closed when it should be open on older Rheem/Ruud furnaces with the blinking status LED board. The switch contacts are stuck or welded closed.
Likely causes
- stuck or welded pressure switch contacts → Shop the pressure switch at RepairClinic
- faulty pressure switch
How to fix it — step by step
- Check the thermostat is set to Heat and calling for heat
- Check the outdoor vent and intake pipes are clear of snow, ice or debris
- On a high-efficiency model, check the condensate drain line and trap are not clogged or frozen
- Turn power off at the furnace switch for 30 seconds, then back on, and try one heat call
- If the code returns, stop resetting and call a licensed HVAC technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the pressure switch.
Parts that commonly fix it
- pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.