Neato Robot vacuum XV Series My vision was blocked. Please press OKAY (1000)
What this problem usually means
The laser sensor (LDS) that measures distance to objects is experiencing problems. Neato's support table groups this message with codes 2000, 3000 and 4000 under the same meaning. In the support table this code carries its own remedy: a full power reset rather than a power cycle.
Likely causes
- The laser sensor is not reporting distance properly
- A latched LDS fault that needs a full power reset to clear
How to fix it — step by step
- Reset the robot: push the battery switch to OFF, wait 5 minutes and turn it back ON
- If your robot does not have a battery switch, disconnect the batteries for 5 minutes instead
- If the issue persists, take the robot to an independent vacuum repair shop — Neato shut down in 2023, so its Customer Care and warranty service no longer exist
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Neato Robot vacuum XV Series problems
- My vision was blocked. Please press OKAY (2000)
- My vision was blocked. Please press OKAY (3000)
- My vision was blocked. Please press OKAY (4000)
- Please press OKAY to continue. Battery issue (0003)
- Please press OKAY to continue. Battery issue (0004)
- Please press OKAY to continue. Battery issue (0005)
- Please press OKAY to continue. Battery issue (0006)
- Please press OKAY to continue. Battery issue (0007)
- Please press OKAY to restart. Battery issue (0002)
- Please press OKAY to restart. Battery issue (0008)
- Please press OKAY to restart. Battery issue (0009)
- Flashing orange light - robot thinks it is charging off the dock