Neato Robot vacuum XV Series My vision was blocked. Please press OKAY (3000)
What this problem usually means
Error 3000 'My vision was blocked' when the laser turret (LDS) is not spinning or not reporting. The recurring root cause is the LDS spin motor: its brushes burn out. If the motor tests good but does not spin in the robot, the C10 capacitor on the 5V bus is the next suspect.
Likely causes
- Burnt brushes in the LDS spin motor (RF-500TB-12560)
- A failed C10 capacitor (220uF 35V) on the 5V bus starving the motor
- A binding turret bearing or belt
- A disconnected Lidar cable
How to fix it — step by step
- Watch the turret at start-up: it should spin counter-clockwise
- Test the LDS motor directly with a low-voltage DC supply; replace it if it does not run (a Jameco 2173044 or equivalent RF-500TB-12560 works - transfer the original connector, and connect the black lead to the motor's + terminal so the turret spins the right way) → Shop the lds spin motor (rf-500tb-12560) at Amazon
- If the motor runs on the bench but not in the robot, replace capacitor C10 (220uF 35V) on the main board
- Check the turret turns freely by hand (unclip the O-ring belt) and that the Lidar cable is seated
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the LDS spin motor (RF-500TB-12560).
Shop the LDS spin motor (RF-500TB-12560) at Amazon
Also tied to this fault: C10 capacitor 220uF 35V - Shop at Amazon
Parts that commonly fix it
- LDS spin motor (RF-500TB-12560) - Shop at Amazon
- C10 capacitor 220uF 35V - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Neato Robot vacuum XV Series problems
- My vision was blocked. Please press OKAY (4000)
- Please press OKAY to continue. Battery issue (0003)
- Please press OKAY to continue. Battery issue (0004)
- Please press OKAY to continue. Battery issue (0005)
- Please press OKAY to continue. Battery issue (0006)
- Please press OKAY to continue. Battery issue (0007)
- Please press OKAY to restart. Battery issue (0002)
- Please press OKAY to restart. Battery issue (0008)
- Please press OKAY to restart. Battery issue (0009)
- Flashing orange light - robot thinks it is charging off the dock
- I had to reset. Please press OKAY to restart
- My battery has a critical error