Neato Robot vacuum XV Series My vision was blocked. Please press OKAY (2000)
What this problem usually means
The laser sensor (LDS) that measures distance to objects is experiencing problems. Neato's support table groups this message with codes 2000, 3000 and 4000 under the same meaning.
Likely causes
- The laser sensor is not reporting distance properly
- An LDS (laser turret) fault that a restart does not clear
How to fix it — step by step
- Power cycle the robot by holding the START button for 20 seconds - Neato's documented fix for this message
- If the issue persists, the LDS unit needs repair or replacement — Neato shut down in 2023, so there is no Neato service anymore; an independent vacuum repair shop is the route that remains
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the LDS (laser turret) unit.
Parts that commonly fix it
- LDS (laser turret) unit - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Neato Robot vacuum XV Series problems
- My vision was blocked. Please press OKAY (3000)
- My vision was blocked. Please press OKAY (4000)
- Please press OKAY to continue. Battery issue (0003)
- Please press OKAY to continue. Battery issue (0004)
- Please press OKAY to continue. Battery issue (0005)
- Please press OKAY to continue. Battery issue (0006)
- Please press OKAY to continue. Battery issue (0007)
- Please press OKAY to restart. Battery issue (0002)
- Please press OKAY to restart. Battery issue (0008)
- Please press OKAY to restart. Battery issue (0009)
- Flashing orange light - robot thinks it is charging off the dock
- I had to reset. Please press OKAY to restart