Lennox Furnace SureLight two-LED control (DS1/DS2) — G40/G50/G51/G60/G61 series DS1 slow flash, DS2 slow flash (alternating)
What this problem usually means
On Lennox furnaces with the two-LED SureLight control (DS1 red, DS2 green; G40, G50, G51, G60, G61 series), slow flashes alternating between DS1 and DS2 mean Watchguard lockout — burners failed to ignite, a limit stayed open over 3 minutes, flame was lost 5 times, or the pressure switch opened 5 times in one cycle. The furnace retries after about an hour.
Likely causes
- Failed igniter or dirty flame sensor (failed ignition) → Shop the flame sensor at RepairClinic
- Restricted airflow holding a limit open
- Vent or drain problem opening the pressure switch repeatedly → Shop the pressure switch at RepairClinic
How to fix it — step by step
- Write down this pattern and note anything the furnace did before locking out
- Check and replace a dirty air filter
- Check outdoor vents and the condensate drain for blockages
- Wait for the Watchguard hour or reset power once; if it locks out again, call a technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the hot surface igniter.
Shop the hot surface igniter at RepairClinic or Amazon
Also tied to this fault: flame sensor - Shop at RepairClinic or Amazon; pressure switch - Shop at RepairClinic or Amazon; limit switch - Shop at RepairClinic or Amazon
Parts that commonly fix it
- hot surface igniter - Shop at RepairClinic or Amazon
- flame sensor - Shop at RepairClinic or Amazon
- pressure switch - Shop at RepairClinic or Amazon
- limit switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace SureLight two-LED control (DS1/DS2) — G40/G50/G51/G60/G61 series problems
- DS1 fast flash, DS2 slow flash
- DS1 off, DS2 slow flash
- DS1 slow flash, DS2 fast flash
- DS1 slow flash, DS2 off
- DS1 slow flash, DS2 on
See all Lennox SureLight two-LED control (DS1/DS2) — G40/G50/G51/G60/G61 series codes & guides →