Lennox Furnace SureLight two-LED control (DS1/DS2) — G40/G50/G51/G60/G61 series DS1 slow flash, DS2 on
What this problem usually means
On Lennox furnaces with the two-LED SureLight control (DS1 red, DS2 green; G40, G50, G51, G60, G61 series), DS1 slow flash with DS2 on means a primary, secondary or rollout limit is open. If a limit stays open 3 minutes the furnace enters a one-hour Watchguard.
Likely causes
- Dirty air filter overheating the furnace
- Closed registers or blocked returns
- Tripped rollout switch
- Failed limit switch → Shop the limit switch at RepairClinic
How to fix it — step by step
- Turn the thermostat down and let the furnace cool
- Replace the air filter and open all registers
- Do not reset a rollout switch yourself → Shop the rollout switch at RepairClinic
- Call for heat once after cooling; if the pattern returns, call a technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the limit switch.
Shop the limit switch at RepairClinic or Amazon
Also tied to this fault: rollout switch - Shop at RepairClinic or Amazon
Parts that commonly fix it
- limit switch - Shop at RepairClinic or Amazon
- rollout switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace SureLight two-LED control (DS1/DS2) — G40/G50/G51/G60/G61 series problems
- DS1 slow flash, DS2 slow flash (alternating)
- DS1 fast flash, DS2 slow flash
- DS1 off, DS2 slow flash
- DS1 slow flash, DS2 fast flash
- DS1 slow flash, DS2 off
See all Lennox SureLight two-LED control (DS1/DS2) — G40/G50/G51/G60/G61 series codes & guides →