Lennox Furnace SureLight two-LED control (DS1/DS2) — G40/G50/G51/G60/G61 series DS1 fast flash, DS2 slow flash
What this problem usually means
On Lennox furnaces with the two-LED SureLight control (DS1 red, DS2 green; G40, G50, G51, G60, G61 series), DS1 fast flash with DS2 slow flash means main power polarity is reversed.
Likely causes
- Line and neutral reversed at the furnace
- Recent electrical work
- Wiring error at the disconnect
How to fix it — step by step
- Confirm the breaker and furnace switch are on
- Do not rewire the supply yourself
- Call an electrician or HVAC technician to correct polarity
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Lennox Furnace SureLight two-LED control (DS1/DS2) — G40/G50/G51/G60/G61 series problems
- DS1 off, DS2 slow flash
- DS1 slow flash, DS2 fast flash
- DS1 slow flash, DS2 off
- DS1 slow flash, DS2 on
- DS1 slow flash, DS2 slow flash (alternating)
See all Lennox SureLight two-LED control (DS1/DS2) — G40/G50/G51/G60/G61 series codes & guides →