Kenmore Dryer 796 Series (LG-Built) d95 Error Code
What the d95 code means
Exhaust vent about 95% blocked on Kenmore 796-series (LG-built) dryers: the ductwork is almost completely blocked, which is a fire risk. The code is only displayed for about 2 hours.
Likely causes
- Severe lint blockage in the ductwork
- Blocked house exhaust system
- Vent run too long or with too many restrictions
How to fix it — step by step
- Do not use the dryer until the exhaust system is cleaned or repaired
- Clean the lint screen and the full vent run, including the outside hood
- Shorten or straighten the vent run if it is too long or has too many turns
- Confirm strong airflow outside on a test cycle before drying clothes again
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the d95 code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.