Kenmore Dryer 796 Series (LG-Built) d90 Error Code
What the d90 code means
Exhaust vent about 90% blocked on Kenmore 796-series (LG-built) dryers: the ductwork is severely restricted, drying will be slow and the dryer runs hot. Do not keep using the dryer until the vent is cleaned.
Likely causes
- Heavy lint blockage in the ductwork
- Crushed or kinked vent
- Blocked outside vent hood
- Vent run too long or with too many turns
How to fix it — step by step
- Stop using the dryer until the vent is checked
- Clean the lint screen and the entire vent run
- Straighten or replace any crushed vent section and clear the outside hood
- Run a test cycle and confirm strong airflow outside before normal use
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the d90 code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.