iRobot Robot mop Braava jet m6 Error 37
What this problem usually means
Mop-specific — Fill the Tank: the tank is too low to start mopping and needs to be refilled. The robot announces it by voice ('Fill the tank'), in the app, and with a red light-ring sweep toward the rear.
Likely causes
- Tank empty or too low to start mopping
- Float sensor inside the tank stuck, so a full tank still reads as low
How to fix it — step by step
- Fill the tank (it holds up to 450 ml) and press CLEAN to resume
- If it reports low with a full tank, remove the tank and shake it vigorously to dislodge the stuck float sensor, then reinstall the full tank
- If it still reports low, add warm water — not hot — and shake the tank again
- If the message persists, reboot the robot: hold CLEAN for 20 seconds, release, and wait for the light ring to finish swirling (over a minute) before pressing CLEAN again
- Contact iRobot Customer Care if the error still returns
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.